SDS

A listing of SDS's
SAFETY DATA SHEET
CCC Thinner
1. IDENTIFICATION
Product Identifiers
Product Name:
CCC Thinner
Other Names:
AB LEIT - CCC Thinner
Product Number(s):
EMS12665; 12665
CAS Number:
Recommended use of the chemical and restriction on use
Laboratory use
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
2. HAZARDS IDENTIFICATION
Classification of the substance or mixture
Mixture
Label Elements
Signal Words
Danger
Hazard Statement(s)
H225: Highly flammable liquid and vapour
H319: Causes serious eye irritation
H336: May cause drowsiness or dizzeness
Precautionary Statement(s)
Keep away from heat/sparks/open flames/hot surfaces. - No smoking
Ground/bond container and receiving equipment
Use explosion-proof electrical/ventilating/lighting/equipment.
Use only non-sparking tools.
Take precautionary measures against static discharge.
Avoid breathing dust/fume/gas/mist/vapours/spray
Wash thoroughly after handling.
Use only outdoors or in a well-ventilated area.
Wear protective gloves/protective clothing/eye protection/face protection.
If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower.
IF INHALED: Remove person to fresh air and keep comfortable for breathing.
If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.
Continue rinsing.
Call a poison center/doctor if you feel unwell.
If eye irritation persists: Get medical advice/attention.
In case of fire: Use for extinction: CO₂, powder or water spray.
Store in a well-ventilated place. Keep container tightly closed.
Store in a well-ventilated place. Keep cool.
Store locked up.
Dispose of contents/container in accordance with local/regional/national/international regulations.
Primary route(s) of entry
Inhalation and skin contact - Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours
after the accident.
Human Health
Inhalation:
Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist.
In case of unconsciousness place patient stably in side position for transportation.
Ingestion:
If symptoms persist consult doctor.
Eyes:
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
Skin:
Immediately wash with water and soap and rinse thoroughly.
Environment
No further relevant information available
3. COMPOSITION/INFORMATION ON INGREDIENTS
Name
CAS No.
Content (w/w)
Classification
n-butyl acetate
123-86-4
>25-≤50%
Not Available
2-methoxy-1-methylethyl acetate
108-65-6
>25-≤50%
Not Available
Acetone, Reagent Grade
67-64-1
>10-≤25%
Not Available
xylene
1330-20-7
>2.5-≤10%
Not Available
4. FIRST AID MEASURES
Ingestion
If symptoms persist consult doctor.
Inhalation
Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist.
In case of unconsciousness place patient stably in side position for transportation.
Skin Contact
Immediately wash with water and soap and rinse thoroughly.
Eye Contact
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
Other Information
Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours
after the accident
5. FIREFIGHTING MEASURES
Suitable extinguishing equipment
CO₂, extinguishing powder or water spray. Fight larger fires with water spray or alcohol resistant foam
HAZCHEM
No further relevant information available.
Special protective equipment and precautions for fire fighters
Mouth respiratory protective device.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Wear protective equipment. Keep unprotected persons away.
See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
Environmental precautions
Dilute with plenty of water.
Do not allow to enter sewers/ surface or ground water
Methods and materials for containment and clean up
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to item 13.
Ensure adequate ventilation.
7. HANDLING AND STORAGE
Precautions for safe handling
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
Conditions for safe storage
Store in a cool location.
Keep receptacle tightly sealed.
Store in cool, dry conditions in well sealed receptacles.
Protect from heat and direct sunlight.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Standards
Material
TWA ppm
TWA mg/m3
STEL ppm
STEL mg/m3
n-butyl acetate
150 ppm
712 mg/m³
200 ppm
950 mg/m³
2-methoxy-1-methylethyl acetate
50 ppm
-
-
Acetone, Reagent Grade
500 ppm
1187 mg/m³
250 ppm
590 mg/m³
xylene
150 ppm
651 mg/m³
100 ppm
435 mg/m³
Engineering controls
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Personal protective equipment
Eye and face protection
Tightly sealed goggles
Skin protection
Protective gloves - The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Body protection
Protective gloves - The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Respiratory protection
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use
respiratory protective device that is independent of circulating air.
9. PHYSICAL AND CHEMICAL PROPERTIES
General information
Appearance
Clear liquid
Odour
Pungent
pH
Not determined.
Vapour Pressure
Not determined.
Density
Not determined.
Boiling Point
55 °C (131 °F)
Melting Point
Undetermined
Solubility
Fully miscible.
Specific Gravity of Density
0.88568 g/cm³ (7.391 lbs/gal)
Flash Point
-19 °C (-2.2 °F)
Flammable (Explosive) Limits
Not flammable, Product is not selfigniting
Product is not explosive. However, formation of explosive air/vapour mixtures are possible.
Ignition Temperature
315 °C (599 °F)
Formula
Organic solvents: 100.0 %
· VOC content: 80.77 %
912.0 g/l / 7.61 lb/gal
Solids content: 0.0 %
· Other information No further relevant information available.
10. STABILITY AND REACTIVITY
Reactivity
No further relevant information available.
Chemical stability
Possibility of hazardous reactions
No dangerous reactions known.
Conditions to avoid
No further relevant information available.
Incompatible materials
No further relevant information available.
11. TOXICOLOGICAL INFORMATION
Acute effects
Harmful; Irritant
Eye contact
Irritating effect.
Skin contact
Irritant to skin and mucous membranes
Ingestion
No further relevant information available.
Inhalation
No further relevant information available.
Toxicity and irritation
IARC (International Agency for Research on Cancer)
1330-20-7 xylene 3
12. ECOLOGICAL INFORMATION
Ecotoxicity
No further relevant information available
Persistence and degradability
No further relevant information available
Bioaccumulative potential
No further relevant information available
Other adverse effects
Water hazard class 1 (Self-assessment): slightly hazardous for water
Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system
13. DISPOSAL CONSIDERATIONS
General information
Must not be disposed of together with household garbage. Do not allow product to reach sewage system.
Disposal must be made according to official regulations.
Water, if necessary with cleansing agents.
14. TRANSPORT INFORMATION
ADG label required
HAZCHEM
No further relevant information available.

UN Number
UN1993
Proper shipping name
FLAMMABLE LIQUID, N.O.S. (ACETONE, BUTYL ACETATES)
Transport hazard class
3 Flammable liquids
Packing group
II
Environmental hazard
Not applicable.
Special precautions for users
Warning: Flammable liquids
· Hazard identification number (Kemler code): 33
· EMS Number: F-E,S-E
· Stowage Category B
Additional information
· Quantity limitations On passenger aircraft/rail: 5 L
On cargo aircraft only: 60 L
· Excepted quantities (EQ) Code: E2
Maximum net quantity per inner packaging: 30 mL
Maximum net quantity per outer packaging: 500 mL
· Limited quantities (LQ) 1L
· Excepted quantities (EQ) Code: E2
Maximum net quantity per inner packaging: 30 mL
Maximum net quantity per outer packaging: 500 mL

· UN "Model Regulation": UN 1993 FLAMMABLE LIQUID, N.O.S. (ACETONE, BUTYL ACETATES), 3, II
15. REGULATORY INFORMATION
Poisons Schedule Number
Other Information
· Section 355 (extremely hazardous substances): None of the ingredients is listed.
· Section 313 (Specific toxic chemical listings): 1330-20-7 xylene
· TSCA (Toxic Substances Control Act): All components have the value ACTIVE.
· Hazardous Air Pollutants: 1330-20-7 xylene
· Proposition 65
· Chemicals known to cause cancer: None of the ingredients is listed.
· Chemicals known to cause reproductive toxicity for females: None of the ingredients is listed.
· Chemicals known to cause reproductive toxicity for males: None of the ingredients is listed.
· Chemicals known to cause developmental toxicity: None of the ingredients is listed.

· EPA (Environmental Protection Agency)
67-64-1 Acetone, Reagent Grade I
1330-20-7 xylene I

· TLV (Threshold Limit Value established by ACGIH) 67-64-1 Acetone, Reagent Grade A4
1330-20-7 xylene A4
16. OTHER INFORMATION
SDS preparation date
29 March 2022
Comments
This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.This Safety Data Sheet (SDS) has been prepared in compliance with the Preparation of Safety Data Sheets for Hazardous Chemicals Code of Practice February 2016. It is the user's responsibility to determine the suitability of this information for adoption of necessary safety precautions. The information published in this SDS has been compiled from the publications listed in Section 16: to the best of our ability and knowledge these publications are considered accurate. We reserve the right to revise Safety Data Sheets as new information becomes available. Copies may be made for non-profit use.
This Safety Data Sheet (SDS) has been prepared in compliance with the Preparation of Safety Data Sheets for Hazardous Chemicals Code of Practice February 2016. It is the user's responsibility to determine the suitability of this information for adoption of necessary safety precautions. The information published in this SDS has been compiled from the publications listed in Section 16: to the best of our ability and knowledge these publications are considered accurate. We reserve the right to revise Safety Data Sheets as new information becomes available. Copies may be made for non-profit use.

... End of SDS ...